Custom Programs; Auto And Sound Active Modes - Blizzard Lighting COLORISE Infiniwhite Manual

Custom Programs:

Allows users to create up to 3 customizable, 20 scene programs that are directly accessible via the control
panel and also in DMX mode.
Creating A Custom Program:
1.) Use the <MENU> and <UP/DOWN> buttons to navigate to PROG, and press <ENTER>.
2.) Now use the <UP/DOWN> buttons to highlight your choice of either CHS1, CHS2, or
CHS3 and press <ENTER>.
3.) Start with editing scene 1 (SC01), customizing it to your liking by using the choices outlined
in the table below. You can mix any color, and set the duration (in seconds) before moving on to
the next scene (TIME 0-255). You can also add a fade in effect to the start of this scene (WAIT
0-255), and/or strobe (SHUT 0-255). Finally, if you want to use this scene in your program, be
sure to enable it (USE: YES/NO).
4.) Repeat the above process to create up to 20 scenes in each of the 3 customizable programs.
A (0-255) - Amber Intensity
W (0-255) - Warm White Intensity
C (0-255) - Cool White Intensity
Running A Custom Program:
1.) To view your newly created lighting masterpiece, use the <MENU> and <UP/DOWN>
buttons to navigate to AUTO, and press <ENTER>.
2.) Use the <UP/DOWN> buttons to highlight your choice of either CHS1, CHS2, or CHS3 and
press <ENTER>. These are also directly accessible from the Effect Channel in DMX mode.

Auto and Sound Active Modes:

Set single or Master/Slaved units to run in sound active or auto mode at user selectable speeds.
Auto Mode:
1.) Use the <MENU> and <UP/DOWN> buttons to navigate to navigate to AUTO, and press
the <ENTER> button.
2.) Now use the <UP/DOWN> buttons to highlight any program ranging from CHS1-CHS3,
and press <ENTER>.
Sound Active Mode:
1.) Use the <MENU> and <UP/DOWN> buttons to navigate to AUTO and press <ENTER>,
then with the <UP/DOWN> buttons navigate to SOU1 (color change), or SOU2 (white strobe
only), and press the <ENTER> button.
Colorise™ Infiniwhite Manual Rev. A
SHUT (0-255) - Strobe (slow - fast)
TIME (0-255) - Scene Time (seconds)
WAIT (0-255) - Fade In (fast - slow)
Page 15
USE (YES/NO) Use Scene in Program?
IMPORTANT:
If USE is set to NO, or TIME is set
to 0, the scene will not run!
© 2015 Blizzard Lighting, LLC