Table of Contents
Advertisement
S
PECIFICATIONS
ITEM
Model No.
Print method
Print head
Print direction
Print speed
High Speed Draft (HSD)
Letter Quality (LQ)
Utility
Line Feed (LF) time
Form Feed (FF) speed
Paper feed control
Duplication capability
Feeding direction
Feeding mode
Continuous forms tape tail
detection method
Character sets
SPECIFICATION
D21008B (ML6300FB)
Impact dot matrix
24 pins, 0.2 mm (0.0079 in) diameter
Bi-directional, short-line-seeking printing
400cps @ 10 cpi
100 cps @ 10 cpi
300 cps @ 10 cpi
Approximately 65 ms per line for LF of 4.23
mm (1/6 in)
Approximately 114.3 mm/s (4.5 in/s)
Paper feed: yes
Vertical tab: yes
Direct line feed: yes
Continuous forms: the original page +5
more pages (total maximum paper thickness
less than 0.36 mm)
Cut sheet: the original page +5 more pages
(total maximum paper thickness less than
0.36 mm)
Feed forward
Feed backward
Friction feed mode (front)
Pin tractor feed mode (rear)
Detected when remaining paper is
approximately 24 mm long. It can, however,
print till about 6 mm from the paper bottom
(measured at the centre of the characters).
(The print accuracy of the last page cannot
be guaranteed.)
Standard ASCII
Epson (Italics/Graphics)
IBM (Set1/Set2)
Foreign
Code Page
Specifications > 62
Advertisement
Table of Contents
