Table of Contents
Advertisement
C
ONTINUOUS FORMS JAMMED IN PRINTER
Do not carry out any operations inside the printer with
the Power Switch set to ON.
1.
Set the Power Switch to OFF.
2.
Tear off any unprinted continuous forms.
3.
Open the Rear Cover by gently pulling it out horizontally
to the end of its travel then swinging it upwards until it
locks into position.
4.
Raise each Pin Tractor cover (1) and remove the
continuous forms from the Pin Tractors.
5.
Rotate the Platen Knob and remove the forms from the
front or rear of the printer.
6.
If a form fragment remains inside the printer, place two or
three forms in a stack on the Pin Tractors and turn the
Platen Knob to push the fragment out of the printer.
7.
When the paper jams are cleared, close the Rear Cover by
gently swinging it downwards to the horizontal and then
pushing it inwards until it locks into position.
8.
Set the Power Switch to ON.
WARNING!
1
Troubleshooting > 46
Advertisement
Table of Contents
