Table of Contents
Advertisement
Repeating (Stroboscopic) Mode
The repeating (stroboscopic) mode
fires the flash multiple times in quick
succession during a single exposure. In
stroboscopic mode, you can adjust flash
output, stroboscopic frequency, and
flash count. Stroboscopic frequency is
measured in hertz (Hz) and indicates
the number of flashes per second.
The flash count (RPT) represents
the number of flashes per frame.
Flash Output
Frequency
To set the FreeWave IR Commander to
stroboscopic mode, follow these steps:
1. Mount the Commander on your
camera.
2. Press the Mode button repeatedly
until the flash output level, Hz, and
Repeating mode indicators appear
onscreen.
3. Press the Set button to make the
flash output level blink, and use the
Left and Right [
buttons to adjust the output from
1/128 to 1/4.
Flash Count
4. Press the Set button to make the
stroboscopic frequency number
blink, and use the Left and Right
[
frequency from 0 to 190.
5. Press the Set button to make the
flash count number blink, and use
the Left and Right [
buttons to adjust the count from
0 to 40.
] navigation
] navigation buttons to adjust the
] navigation
23
Advertisement
Table of Contents
