Table of Contents
Advertisement
TCP/IP Tab
This allows you to configure TCP/IP related items.
Location
Comments
Use TCP/IP
Set TCP/IP protocol as enabled/disabled.
Protocol
Use DHCP/
Check this item if IP address, subnet mask, default gateway and IP
BOOTP
addresses for DNS primary server and secondary servers are retrieved
from the DHCP or BOOTP server. Otherwise, uncheck.
Use RARP
Check this item if IP address is retrieved from the RARP server.
Otherwise, uncheck.
IP Address
Set the IP address of the selected network interface card.
Subnet Mask
Set the subnet mask of the selected network interface card.
Default Gateway Set the default gateway of the selected network interface card.
Use FTP/LPD
Check this item if you want to add the FTP/LPD banner. Otherwise,
Banner
uncheck.
DNS Server . . .
Set IP addresses for DNS primary and secondary servers.
Network PnP
Configure items related to Network PnP.
Setup ...
In this dialogue box, the following items can be configured>
Auto IP address
Use Network PnP
Device Name
Netware Tab
This is where you can configure NetWare related items.
Location
Use NetWare Protocol
Use IPX Protocol / Use TCP/IP
Protocol
Comments
Set NetWare protocol as enabled/disabled.
Set protocol to use.
Network Configuration 15
Set to get IP address
dynamically by Auto IP,
enabled or disabled
Set notifying users with
using UPnP supported OS
of the printer, enabled or
disabled
Set the device name for
Network PnP
Advertisement
Table of Contents
