Pedal - Yowza jupiter Assembly Instructions And Owner's Manual

46 YOWZA JUPITER CROSSTRAINER
COMPUTER OPERATION
COMPUTER OPERATION:
POWER ON
Turn on the power switch at the rear of elliptical, and the computer will reset automatically and "L1" blinks till a "Beep".
Then all graphic digits will display
QUICK START:
Press the START button to quick-start exercise
1. Intensity starts from Level 1, press to INTENSITY UP/DOWN
2. Level starts from Level 1, press MOTION UP/DOWN or using the Thumb touch control sensor on the hand grips of the right
action handlebar.
FAN:
First Press: Second Press: Third Press:
Fourth Press: STOP
PAUSE/STOP:
During the workout, press STOP button or STOP pedaling for 30 seconds to enter PAUSE status. The INTENSITY LEVEL Dot
Matrix display will show "PAUSE". All figures on the console will be frozen. Press the START button or start pedaling to
resume the program and the display will continue the workout until the program finishes. If you leave the pedal stopped for
over 3 minutes or press the STOP button, all the data will return to 0 and the computer will return to POWER ON status.
SLEEP MODE:
The computer will automatically enter SLEEP MODE if left idle for 3 minutes without any input in POWER ON status. When
the computer is in SLEEP MODE, press any button or pedal and the machine will return to POWER ON status. You can turn
SLEEP MODE off but the console will be drawing power indefinitely if it plugged in to keep the LCD lit. To turn SLEEP MODE
off, get the console to POWER ON status then press INTENSITY UP/DOWN and START three buttons on the computer and
hold them for 3 seconds. The computer will sound one short beep and "Sr-1" blinking. Press START button to enter
conversion SLEEP MODE function. After Press the START button the computer will display either "On" or "Off" blinking then
press INTENSITY UP/DOWN button to switch between "On" and "Off" then press STOP/ENTER button twice to return to the
POWER ON status.