Table of Contents
Advertisement
Location and Functions of Control
Communication Connections
1
TRIG : output voltage of 5 V when projector is on.
2
MOUSE : mouse output to be connect to the mouse input of a computer. The computer can now be controlled via the Executive
Remote Control Unit.
3
RS232 IN : to allow communication with external computer, e.g. IBM PC or compatible, Macintosh ...
4
RS232 OUT : used to connect to next projector, RS232IN plug (communication link for PC or MAC to the next projector).
5
Communication port : allows communication with the 800 peripherals.
6
IR-Acknowledged : IR signals are recognized.
IR-Received : IR signals are received but not recognized by the projector.
7
Projector mode indication : indicates the status of the projector.
8
Diagnostics code :
9
Remote : remote input for wired remote control.
10
IR receiver : receiver for control signals transmitted from the RCU.
Control Panel Terminology
The projector can be controlled by the local keypad or by the remote control unit.
a. Local keypad
The local keypad is located on the backside of the projector.
3-2
Downloaded From projector-manual.com Barco Manuals
VIDE O
R
G
Light off : power switch is not pressed.
Red light : power switch is pressed, projector in stand by mode.
Green light : projector in operational mode.
a) source number
b) error code : a two digit error code is displayed when something goes wrong inside the projector.
1
3
4
6
S-VIDE O
S DI
5
IEEE 139 4
TRIG
SDO
COMPU TER
2
MONITOR
B
H /C
V
1
2
3
4
5
6
7
C OMM. PO RT
MOUSE
R S2 32 IN
RS2 32 O UT
B
C
A UD IO IN
A
AUDIO IN
AUD IO IN
5976069 BARCOREALITY 6400 21082000
8 9 10
RC
A UDIO OUT
Advertisement
Table of Contents
