Table of Contents
Advertisement
b. Remote control
This remote control includes a battery powered infrared (IR)
transmitter that allows the user to control the projector remotely.
This remote control is used for source selection, control,
adaptation and set up. It includes automatic storing of :
- picture controls (Brightness, Sharpness...)
- settings
Other functions of the remote control are :
- switching between standby and operational mode.
- switching to "pause" (blanked picture, full power for
immediate restarting)
- direct access to all connected sources.
Local keypad
Terminology
1
Function keys : user programmable keys with functions for direct access.
2
ADJ. : to escape the adjustment mode.
3
Address key (recessed key), to enter the address of the projector (between 0 and 9). Press the recessed address key with
a pencil, followed by pressing one digit button between 0 and 9.
4
Selection key : to direct access the zoom/focus/shift functions.
5
PAUSE : to stop projection for a short time, press 'PAUSE'. The image disappears but full power is retained for immediate restarting.
6
STBY : stand-by button, to start projector when the power switch is switched on and to switch off the projector without switching
off the power switch.
Attention : Switching to Stand-by.
When the projector is running and you want to go to stand-by, press the stand-by key for 2 seconds until the message 'Saving
data, please wait' is displayed. Do not press any longer on the stand-by key otherwise the projector will restart.
7
Mute : to interrupt the sound reproduction.
8
? : Auto image, to center the image on the active LCD surface.
9
Digit buttons : direct input selection.
10
Audio controls : use these buttons to obtain the desired sound level (see also 'Controlling').
11
Picture controls : use these buttons to obtain the desired picture analog level (see also 'Controlling').
12
PHASE : used to remove the instability of the image.
5976069 BARCOREALITY 6400 21082000
Downloaded From projector-manual.com Barco Manuals
0
9
STANDBY
7
8
ENTER
6
5
TEXT
PAUSE
3
4
TINT
SHARPN
BRIGHTN
1
2
PHASE
COLOR
CONTRAST
Location and Functions of Control
Remote Control (RCU)
1
2
3
4
5
6
6
7
16
8
17
9
EXIT
15
5
14
11
10
12
9
18
F3
F2
F4
F1
F5
17
ADJ
EXIT
16
15
ENTER
14
13
PAUSE
TEXT
12
PHASE
9
0
SHARPN
7
8
TINT
6
5
11
COLOR
3
4
BRIGHTN
1
2
CONTR
TREBLE
BALANCE
BASS
VOL
3-3
Advertisement
Table of Contents
