Table of Contents
Advertisement
Unpacking and Dimensions
Battery installation in the RCU.
Two batteries are packed together with the RCU. Before using your RCU, install first these batteries.
1
Remove the battery cover on the backside by pushing the handle a little towards the bottom of the RCU.
2
Lift up the top side of the cover at the same time.
3
Insert the batteries as indicated in the RCU.
4
Put the battery cover on its place.
How to replace the batteries in the RCU ?
To replace the batteries :
1
Remove the battery cover on the backside by pushing the handle a little towards the bottom of the RCU.
2
Lift up the top side of the cover at the same time.
3
Push on the + side of the battery towards the - side
4
Lift up the battery at the same time.
5
Repeat for the second battery.
6
Insert the batteries as indicated in the RCU (battery type AA or LR6 or equivalent).
7
Put the battery cover on its place.
Note, only important if more than one projector is installed in the room :
1. the common address can be zero (0) or one (1). The standard RCU are setup for common address zero. To change the common address
of the RCU, contact a BARCO service center. If it is necessary to program the projector address into the RCU, see chapter 'Controlling'.
2. projector address has to be reprogrammed everytime the battery is changed, the RCU will always switch to the default address.
1-2
Downloaded From projector-manual.com Barco Manuals
5976069 BARCOREALITY 6400 14032000
Advertisement
Table of Contents
