Receiving A Call; Using The Radio In Different Repeater Areas - Tait TM9300 User Manual

Using a function key
1 Select the required channel.
2 Press the programmed function key to turn
repeater talkaround on. The message Talkaround
activated appears briefly, and the repeater
talkaround icon
3 Proceed with your call.
4 To turn repeater talkaround off, either change the
channel, or press the function key again.

Receiving a call

When there is valid activity on your radio's currently
selected channel or group, the radio then unmutes
and you can hear the call.
If an incoming analog call contains special signaling
that matches the signaling programmed for your radio,
the green LED flashes and your radio may give a
ringing tone.
Using the radio in different
repeater areas
Your radio may have a group of channels
programmed as a voting group. The channels in the
voting group all carry the same traffic, but from
different repeaters. As your radio moves in and out of
different repeater coverage areas, the best
communication channel is automatically selected for
you to use, until a better communications channel is
selected.
This channel is known as the 'home' channel, and will
be the channel you make and receive calls on. While
voting is active, the orange LED glows and the
scanning icon
appears on the display.
appears on the display.
Operating in conventional mode 61