Path Jam - Oki C9500 Maintenance Manual

2-3 Path jam

• Do path jams occur right after power ON?
• Yes Is the jam at the entrance belt sensor?
Yes Remove the jammed paper.
(A)
• No Does the light sensor lever function properly?
No Replace the light sensor lever.
• Yes Does the belt sensor lever function properly?
(Operate the sensor lever and check the FSENS connector pin signal on the engine board
(K7N PWB).)
Pin 6: Entrance belt sensor
No Check the cable connections, then replace the sensor board (R71 PWB).
• Yes Check the signal cable.
Is it connected properly?
No Connect the cable properly.
• Yes Replace the engine board.
• No Do path jams occur right after papers are absorbed?
• Yes Did the paper reach the light sensor?
Yes Proceed to (A).
• No Is the resist motor rotating?
• No Is the main feed motor resistance within the regulated value (approx. 7.9Ω)?
No
• Yes Check the gear mesh status, then replace the engine board.
• Yes Replace resist motor A or B.
• No Do path jams occur upon loading paper?
• Yes Is the belt motor rotating?
• No Is the belt motor resistance within the regulated value (approx. 7.9Ω)?
No
• Yes Check the gear mesh status, then replace the engine board.
• Yes Check the gear mesh status, then replace the belt cassette assembly.
• No End.
41956001TH Rev.6
Replace the resist motor.
Replace the belt motor.
Oki Data CONFIDENTIAL
115 /