Configuring Hp-Ux V9.Xx For Printing With The Okilan 6120I - Oki OkiLAN 6120i User Manual

Section 4 - Appendix B - Application Considerations
6. Enable the printer you just created using SAM.
7. Printer name: — lj4
8. Start the LP request scheduler by typing:
9. Run a test print job to the OkiLAN 6120i with the
following command:
Configuring HP-UX v9.xx for Printing
with the OkiLAN 6120i
This application note describes the configuration of the
printing system on the HP-UX ver. 9.xx of the UNIX
operating system. For clarity and brevity, the following
specific names will be used to represent general
devices or concepts.
• lj4 - The local queue name on the HP-UX system
to which print jobs will be directed. The print jobs
are destined for a printer attached to the OkiLAN
6120i.
• OKIPRINTER - The host name of the remote
system which is the OkiLAN 6120i. For example,
to telnet to the OkiLAN 6120i and invoke the
OkiLAN 6120i Configuration utility, you would
type telnet OKIPRINTER. A host name is not
required for the OkiLAN 6120i, the IP Address
may be used.
• yourqueuename - This is the name of the queue
on the OkiLAN 6120i and must end with 1, 2, 3
or 4, depending on the port selected to service the
print jobs.
If FF, LF or NF are the last two letters of the
queue name, the job will be converted
accordingly. See pages IV-15 and IV-16 for more
information on Remote Queue Names.
IV - 66
Peripheral Devices ->
Printers and Plotters ->
Enable a Printer ...
/usr/lib/lpsched
lp -d lj4 filename
OKI OkiLAN 6120i User's Guide