Assembling The Vacuum Shredder - Stihl BGE 71 Instruction Manual

English
2
4
3
Line up the recesses. The arrow (2)
N
must be on the top of the blower
tube (1).
Push the blower tube (1) into the fan
N
housing stub (3) as far as the stop.
Push the union nut (4) over the fan
N
housing stub (3) and turn it in the
direction of the arrow as far as the
stop. You will hear the safety switch
being activated.
Mounting the Nozzle
6
Push the nozzle (5) onto the blower
N
tube (1) as far as lug (6),
position (a) (long) or position (b)
(short), and rotate the nozzle in the
direction of the arrow to it lock in
position.
28
Removing the Blower Tube (BGE 61)
Switch off the motor.
N
Insert a suitable tool through the
N
opening in the union nut to press
down the tab.
Rotate the union nut (4) in the
N
direction of the arrow as far as the
stop.
Remove the blower tube (1).
N
Removing the Blower Tube (BGE 71,
BGE 81)
a b
Switch off the motor.
N
Rotate the union nut (4) in the
N
direction of the arrow as far as the
stop.
Remove the blower tube (1).
N
4
4
BGE 61, BGE 71, BGE 81, SHE 71, SHE 81
Assembling the Vacuum
Shredder
Your vacuum shredder can be switched
on only when the elbow and suction tube
are properly mounted. The union nuts
activate a switch which closes the circuit
to allow the motor to be switched on.
Disconnect the plug from the power
N
supply.
Mounting the Elbow
3
1
Push the elbow (1) into the catcher
N
bag (2) as far as the mark (smaller
arrow).
Tighten strap (3) on catcher bag
N
and press down the tab (4).
WARNING
Make sure the zipper on the catcher bag
is closed.
2
4