Reset To Factory Setting / Reset To Factory Setting; Emptying The System Emptying The System - Nespresso PRODIGIO&MILK Instruction Manual

Reset to Factory Settings /
If reset to factory setting,
Min 4 sec
will cancel the pairing, reset the
capsules stock management and
the descaling alert.
If reset to factory setting,
will cancel the pairing, reset the
capsules stock management and
the descaling alert.
Emptying the System
Emptying the System
To note, the machine remains blocked for 10 minutes after emptying!
To note, the machine remains blocked for 10 minutes after emptying!
Remove the water
Place a container under
the coffee outlet.
Remove the water
Place a container under
the coffee outlet.
Reset to Factory Settings
Factory settings are:
this
- Lungo, Espresso, Ristretto coffee buttons 110ml /
3.7oz, 40ml / 1.35 oz., 25ml / 0.84 oz.
- Automatic OFF mode after 9 minutes.
- The water hardness set by default is hard, which
corresponds to around 1000 Espresso cups.
this
To do it via your machine:
1. Ensure the machine is turned OFF.
2. Press and hold Espresso & Lungo buttons for at least
5 seconds.
All the coffee buttons and LEDs will blink once as
confirmation. To unpair your machine, please refer to the
«Troubleshooting section».
before a period of non-use or for frost protection /
before a period of non-use or for frost protection
tank. Ensure the machine
> 6 sec
is ON, press and hold
the Ristretto & Lungo
buttons together for
tank. at least 6 seconds.
Ensure the machine
is ON,
the Ristretto & Lungo
buttons together for
at least 6 seconds.
Job: NES-432001-2003Q-3 ProdigioMilk
Objekt: qInlet
Version: --
Seite: q19
Factory settings are:
- Lungo, Espresso, Ristretto coffee buttons 110ml /
3.7oz, 40ml / 1.35 oz., 25ml / 0.84 oz.
- Automatic OFF mode after 9 minutes.
- The water hardness set by default is hard, which
corresponds to around 1000 Espresso cups.
To do it via your machine:
1. Ensure the machine is turned OFF.
2. Press and hold Espresso & Lungo buttons for at least
5 seconds.
All the coffee buttons and LEDs will blink once as
confirmation. To unpair your machine, please refer to
the «Troubleshooting section».
The Ristretto and Lungo coffee buttons will
flash
start procedure. If the slider was already closed,
the emptying process starts automatically. When
the procedure is finished, clean the drip tray and
the cup support. Machine turns to OFF mode
automatically when empty.
The Ristretto and Lungo coffee buttons will flash
confirmation. Then close the slider to start procedure. If the slider
press and hold was already closed, the emptying process starts automatically. When
the procedure is finished, clean the drip tray and the cup support.
Machine turns to OFF mode automatically when empty.
Datum: 15-06-05
Uhrzeit: 15:03:43
von: timea.trojko
EN
FR
for confirmation. Then close the slider to
for
21