Microplex LOGIJET TC8 Operator's Manual page 5

_______________________________________________________________________________________________
Chapter
7.23. Image Shifting to the X-Direction
7.24. Image Shifting to the Y-Direction
7.25. Aligning the Colors to each other (Color Image shifting X/Y-direction)
7.26. Selecting and Adjusting the Sync Sensor
7.26.1. Selecting the Light Sensor Type (Gap or Reflex)
7.26.2. Checking and Adjusting the Position of the Sensors
7.26.3 Automatic Adjust of Level and Current
7.26.3.1. Overview
7.26.3.2. Example
7.26.4 Manual Adjusting of Level and Current
7.26.4.1. Overview:
7.26.4.2. Description of the Working Steps
7.26.4.3. Example
7.27. Adjusting the Zero Position of the Material Transport (Sync.Sens.Offset)
7.28. Peripheral Device Activation (Tear Off Edge, Cutter)
7.29. Selecting the Tear Off Mode (Option: Cutting Mode)
7.30. Selecting the Print Mode
7.31. Adjusting the Tear Off Position (Option: Cutting Position)
7.32. Configuration of Network Parameters (IP Address, e.g.)
8. Operator Maintenance
8.1. Printer Cleaning
8.1.1. Printer Cabinet Cleaning
8.1.2. Cleaning the Printheads
8.1.3. Platen Roller Cleaning
8.1.4. Cleaning the Sensors
8.2. Avoiding Ribbon Slack and Wrinkles
8.3. Check the Printhead Pressure
9. Troubleshooting
9.1. Error Messages
9.2. Reduced Print Quality
9.3. Incorrect Media Transport
9.4. Clearing Paper Jam
9.5. Print Repetition after an Error
_______________________________________________________________________________________________
MICROPLEX Operator's Manual LOGIJET TC8
Contents 5
Page
103
105
107
108
108
109
114
114
115
116
117
118
119
121
123
125
127
130
132
135
135
136
137
141
144
147
153
154
155
158
160
162
165
Edition 1.1