Download Print this page
BARIX Extreamer 100 Quick Install Manual

BARIX Extreamer 100 Quick Install Manual

Multiformat ip audio decoder

Advertisement

EXSTREAMER
100
Quick Install Guide
Version 2.0
Mulitformat IP Audio Decoder
Package contents
a
Exstreamer 100
b
Power supply
c
RCA Stereo cable
Cable Set AUDIO (not included)
d
Earphone
e
RCA Stereo cable
f
Network cable
g
Serial cable
Firmware
This device comes preloaded with standard firmware.
Alternative firmware can be downloaded from www.barix.com.
Support
For support please contact your local dealer or visit www.barix.com.
© Barix AG 3/2013, all rights reserved. All information is subject to change without notice. All mentioned trademarks belong
to their respective owners and are used for reference only. Barix, Exstreamer and SonicIP are trademarks of Barix AG, Switzerland,
and are registered in certain countries.

Advertisement

loading
Need help?

Need help?

Do you have a question about the Extreamer 100 and is the answer not in the manual?

Questions and answers

Summary of Contents for BARIX Extreamer 100

  • Page 1 © Barix AG 3/2013, all rights reserved. All information is subject to change without notice. All mentioned trademarks belong to their respective owners and are used for reference only. Barix, Exstreamer and SonicIP are trademarks of Barix AG, Switzerland, and are registered in certain countries.
  • Page 2 Front view Rear view Reset button LAN port 10/100 (RJ45 Ethernet socket) A brief press of the button will reset the device. Description Holding the reset button pressed in for approximately Tx + 10 seconds will reset the device and restore the factory default settings when the button is released.
  • Page 3 STEP 1 Plug a standard (straight) network cable (f, not included) Most Barix applictaions require no configuration but use into the network port (G) of the Exstreamer and the DHCP to configure network settings dynamically. other end into your hub or switch. You can also use a...
  • Page 4 -s 192.168.0.6 00-08-E1-00-B1-77 documentation, latest firmware, support and access to or on a OSX or Linux system type into the terminal the user forum please visit www.barix.com. arp -s 192.168.0.6 00:08:E1:00:B1:77 and hit the «Enter» key (replace the digits according to your devices MAC address).