Advertisement
EXSTREAMER
120
Quick Install Guide
Version 2.0
Mulitformat IP Audio Decoder
Package contents
a
Exstreamer 120
b
Power supply
c
RCA Stereo cable
d
IR remote control
e
Batteries (2 x AAA)
Cable Set AUDIO (not included)
f
Earphone
g
RCA Stereo cable
h
Network cable
i
Serial cable
Firmware
This device comes preloaded with standard firmware.
Alternative firmware can be downloaded from www.barix.com.
Support
For support please contact your local dealer or visit www.barix.com.
© Barix AG 3/2013, all rights reserved. All information is subject to change without notice. All mentioned trademarks belong
to their respective owners and are used for reference only. Barix, Exstreamer and SonicIP are trademarks of Barix AG, Switzerland,
and are registered in certain countries.
Advertisement
Related Manuals for BARIX EXSTREAMER 120
Summary of Contents for BARIX EXSTREAMER 120
- Page 1 © Barix AG 3/2013, all rights reserved. All information is subject to change without notice. All mentioned trademarks belong to their respective owners and are used for reference only. Barix, Exstreamer and SonicIP are trademarks of Barix AG, Switzerland, and are registered in certain countries.
-
Page 2: Front View
Front view Rear view Reset button LAN port 10/100 (RJ45) Standard RJ45 Ethernet socket A brief press of the button will reset the device. Holding the reset button pressed in for approximately Description 10 seconds will reset the device and restore the factory Tx + default settings when the button is released. - Page 3 STEP 1 Plug a standard (straight) network cable (h, not included) Most Barix applictaions require no configuration but use into the network port (H) of the Exstreamer and the DHCP to configure network settings dynamically. other end into your hub or switch. You can also use...
-
Page 4: Troubleshooting
-s 192.168.0.6 00-08-E1-00-B1-77 documentation, latest firmware, support and access to or on a OSX or Linux system type into the terminal the user forum please visit www.barix.com. arp -s 192.168.0.6 00:08:E1:00:B1:77 and hit the «Enter» key (replace the digits according to your devices MAC address).