Fujitsu M3096GX Instruction Manual page 132

f BLOCK DESCRIPTOR LENGTH: Byte 3
Specifies the length of the entire mode parameter descriptor block in units of
byte. The page and vendor>specific parameter are not included.
In this scanner, 0 is specified and the succeeding mode descriptor section shall
be omitted.
b. Mode parameter descriptor block (Omitted in this scanner)
The mode parameter data (mode descriptor block) is shown below:
7
Byte 0
1
(MSB)
2
3
4
5
(MSB)
6
7
f NUMBER OF BLOCKS: Byte 1 to 3
Specifies the number of logical blocks fitted for the DENCITY CODE and
BLOCK LENGTH.
f BLOCK LENGTH: Bytes 5 to 7
Specifies the length of the logical blocks described in the BLOCK
DESCRIPTOR in units of byte.
Note:
In this scanner, this descriptor is omitted.
4 $ 100
6 5 4
(Reserved)
Number of blocks
Parameter list length
Block length
3 2 1 0
(LSB)
(LSB)