Table of Contents
Advertisement
Changing the password
1.
Open the OSD menu and go to the System Setup: Advanced >
Security Settings > Change password menu.
2.
Press MODE/ENTER. The message 'INPUT CURRENT
PASSWORD' displays.
3.
Enter the old password.
•
•
4.
Enter a new password.
The digits being input will display as asterisks on-screen. Write your selected
password down here in this manual in advance or right after the password is
entered so that it is available to you should you ever forget it.
Password: __ __ __ __ __
Keep this manual in a safe place.
5.
Confirm the new password by re-entering the new password.
6.
You have successfully assigned a new
password to the projector. Remember
to enter the new password next time
the projector is started.
7.
To leave the OSD menu, press MENU/
EXIT.
Disabling the password function
To disable password protection, go back to the System Setup: Advanced
> Security Settings > Change Security Settings menu after opening the
OSD menu system. Press MODE/ENTER. The message "INPUT
PASSWORD" appears. Enter the current password.
1.
If the password is correct, the OSD menu returns to the Security
Settings. Press ▼ highlight Power On Lock and press ◄/► to select
Off. You will not have to enter the password next time you turn on the
projector.
Press ▼ to highlight Web Control Lock and press ◄/► to select
Off. The Web Control Lock function is released and the projector
settings can be change via the Projector Network System.
2.
If the password is incorrect, the password error message displays lasting
for three seconds, and the message 'INPUT PASSWORD' displays
34
Operation
If the password is correct, another message 'INPUT NEW
PASSWORD' displays.
If the password is incorrect, the password error message displays
lasting for three seconds, and the message 'INPUT CURRENT
PASSWORD' displays for your retry. You can press MENU/
EXIT to cancel the change or try another password.
Password Changed
Advertisement
Table of Contents
