Table of Contents
Advertisement
Setting the User 1/User 2 mode
There are two user-definable modes if the current available picture modes
are not suitable for your need. You can use one of the picture modes (except
the User 1/User 2) as a starting point and customize the settings.
1.
Press MENU/EXIT to open the On-Screen Display (OSD) menu.
2.
Go to the Picture > Picture Mode menu.
3.
Press ◄/► to select User 1 to User 2.
4.
Press ▼ to highlight Reference Mode.
This function is only available when User 1 or User 2 mode is selected up in
the Picture Mode sub-menu item.
5.
Press ◄/► to select a picture mode that is closest to your need.
6.
Press ▼ to select a sub-menu item to be changed and adjust the value
with ◄/►. See
details.
Fine-tuning the image quality in user modes
According to the detected signal type, and selected picture mode, some of
the functions listed below may not be available. Base on your need, you can
make adjustments to these functions by highlighting them and press ◄/► on
the projector or remote control.
Adjusting Brightness
The higher the value, the brighter the image.
And lower the setting, darker the image.
Adjust this control so the black areas of the
image appear just as black and that detail in the
dark areas is visible.
Adjusting Contrast
The higher the value, the greater the contrast.
Use this to set the peak white level after you
have previously adjusted the Brightness
setting to suit your selected input and viewing
environment.
Adjusting Color
Lower setting produces less saturated colors. If the setting is too high, colors
on the image will be overpowering, which makes the image unrealistic.
Adjusting Tint
The higher the value, the more reddish the picture becomes. The lower the
value, the more greenish the picture becomes.
Adjusting Sharpness
The higher the value, the sharper the picture becomes. The lower the value,
the softer the picture becomes.
40
Operation
"Fine-tuning the image quality in user modes"
below for
+50
+30
0
+30
+7
-3
Advertisement
Table of Contents
