Entering The Password Recall Procedure; Changing The Password; Closing The Password Function; Switching Input Signal - BenQ Commuter Series User Manual

Entering the password recall procedure

Press and hold
screen. Seek help from the local BenQ service center to decode the number. You may be
required to provide proof of purchase documentation to verify that you are an authorized
user of the projector.

Changing the password

1. Open the on-screen menu and go to
2. Press Left or
3. Enter the old password.
i. If the password is correct, you can go on to enter new password.
IMPORTANT: Write your selected password down here in this manual so that it is available to
you should you ever forget it.
Password: __ __ __ __
Keep this manual in a safe place.
ii. If the password is incorrect, a "Password Error" message displays. Press
try again or press
4. Check the new password.
i. Pressing AUTO completes the procedure.
ii. Press
iii. Press

Closing the password function

To disable password protection, go back to
screen menu. Select Off by pressing
password next time when turning on the projector.

Switching input signal

The projector can be connected to multiple devices at
the same time. However, it can only display one at a
time. To cycle through the available input sources,
press the SOURCE button on the projector control
panel or the remote control. The selected source
name will display at the center of the screen for 3
seconds after each button press.
The brightness level of the projected image will
change accordingly when you switch between
different input signals. Data (graphic) "PC"
presentations using mostly static images are generally
brighter than "Video" using mostly moving images (movies).
The input type affects the options available for the Application Mode. See
application mode" on page 26
Right for 5 seconds. The projector will display a coded number on the
Right. A "Password Change" message displays.
Down to cancel.
Up to try again.
Down to cancel the set-up and return to the on-screen menu.
Left or
for details.
Setting > Change Password.
Setting > Password after opening the on-
Right and you will not have to enter a
Up to
"Selecting an
Operation 23