Setting Up The Device; Vertical Operating Position With Feet (Optional) - Fujitsu ESPRIMO D5 Series Operating Manual

Getting started

Setting up the device

Device, Ergonomic Videoworkstation
When setting up your device, please read the recommendations and
safety notes in the "Safety/regulations" manual.
We recommend that you place your device on a surface with good anti-slip qualities.
In view of the multitude of different finishes and varnishes used on furniture, it is
possible that the rubber feet will mark the surface they stand on.
Depending on the location of your device, bothersome vibrations and noises may
occur. To prevent this, a distance of at least 10 mm / 0.39 in should be maintained
from other devices on casing sides without ventilation surfaces.
In order to avoid overheating, do not cover the ventilation areas
on the monitor or the device.
A minimum distance of 200 mm / 7.87 in from the device must be
observed for ventilation areas.
Do not stack several devices on top of each other.
Do not expose the device to extreme ambient conditions (see
Page 76, "Ambient conditions"). Protect the device against dust, humidity and heat.
Operating position
You can use the device in a vertical or horizontal operating position.
With the aid of suitable feet, it is possible to use the device in a vertical operating position
"Vertical operating position with feet (optional)", Page
(see

Vertical operating position with feet (optional)

Use the optional feet when you wish to use the device in the vertical operating position.
The set-up direction is compulsory: The ON/OFF switch must be at
the top to ensure sufficient ventilation.
You must remove the feet again to be able to open the device.
Base feet Verticaloperatingposition Operatingposition,vertical Sidecover
Proceed as follows to operate the device in the vertical operating position with the feet:
► If necessary, disconnect the cables connected to the device.
16
"Technical specification",
16).
Fujitsu