No Mouse Pointer Displayed On The Screen; Time And/Or Date Is Not Correct; Smartcard Reader Is Not Recognised - Fujitsu ESPRIMO D5 Series Operating Manual

Problem solutions and tips

No mouse pointer displayed on the screen

Cause
The mouse is not correctly connected.
Disabled USB ports

Time and/or date is not correct

Cause
Time and date are incorrect.
The lithium battery is discharged.

SmartCard reader is not recognised.

Cause
Chip card inserted incorrectly.
32
Remedy
► Shut down your operating system in the
proper manner, for instance using
Alt + Del .
► Switch the device off.
► Check that the mouse cable is properly
connected to the system unit. If you use an
adapter or extension lead with the mouse
cable, check the connections.
► Make sure that only one mouse is
connected.
► Switch the device on.
► In the BIOS Setup, check whether the USB
ports are Enabled (see the "BIOS Setup"
manual or the mainboard manual
Remedy
► Set the correct time and date within the
operating system you are using.
or
► Set the correct time and/or date in the
BIOS Setup.
► If the time and date are repeatedly wrong
when you switch on your device, replace the
lithium battery (see
battery", Page 75).
Troubleshooting
► Make sure you have inserted your
SmartCard into the SmartCard reader with
the chip facing upwards.
► Check whether the SmartCard you are using
is supported. Your SmartCard must comply
with the ISO standard 7816-1, -2, -3 and -4.
+
Ctrl
"Replacing the lithium
Fujitsu