Panasonic KX-MB2085CX Operating Instructions Manual page 96

11. Help
Problem
The [Windows Security Alert]
dialogue box appears and
asks if I want to block
[PCCMFLPD] and I cannot
operate the following
functions after installing the
Microsoft Windows XP
Service Pack 2 or later.
– PC printing
– Scanning
– Remote Control
– PC FAX
– Device Monitor
11.4.7 Using an answering machine
Problem
I cannot receive documents
automatically.
I cannot receive voice
messages.
I pressed the remote access
code to access the answering
machine remotely, but the line
was disconnected.
Callers complain that they
cannot send a document.
11.4.8 If a power failure occurs
R The unit will not function.
R If any documents are stored in the memory (i.e. during copying, PC printing), they will be lost.
R The unit is not designed for making emergency telephone calls when the power fails. Alternative arrangements
should be made for access to emergency services.
R Fax transmission and reception will be interrupted.
R Documents during fax transmission or fax reception will be lost.
R When power is restored, a power down report will be printed out stating which fax items in the memory have been
erased.
11.4.9 Firewall setting tool for Microsoft Windows users (KX-MB2090, LAN connection only)
After installing Microsoft Windows XP Service Pack 2 or later/Windows Vista/Windows 7/Windows 8, you will not be
able to use the following functions because the Windows Firewall feature will be activated and block the connection.
– Device Monitor
– LPD Manager (Network communication tool)
The Windows Firewall Setting Tool enables you to change the Windows Firewall security settings and to use the
above functions properly.
1
Insert the CD-ROM that is supplied with the unit into your CD-ROM drive.
R If the [Select Language] dialogue box appears, select the desired language that you want to use with this
software. Click [OK].
96
Cause & Solution
R Click [Cancel] and run the Windows Firewall Setting Tool to allow the data
transmission for Multi-Function Station (page 96).
Cause & Solution
R Your greeting message on the answering machine is too long. Shorten the
message. Record a message less than 10 seconds long.
R The answering machine rings too many times. Set to 1 or 2 rings.
R Check if the answering machine is turned ON and connected to the unit
properly (page 48).
R Set the number of rings on the answering machine to 1 or 2.
R The code may include "#" which is used for certain features provided by
telephone companies. Change the code on the answering machine to
another number which does not include "#".
R There is no room left in the memory of your answering machine to record
voice messages. See the operating instructions of the answering machine
and erase unnecessary messages.
R You set the answering machine to only give a greeting message.