Important Information; For Your Safety - Panasonic KX-MB2085CX Operating Instructions Manual

For your safety

Laser radiation
CLASS 1 LASER PRODUCT
R The printer of this unit utilises a laser. Use of controls
or adjustments or performance of procedures other
than those specified herein may result in hazardous
radiation exposure.
Laser diode properties
Laser output : Max. 15 mW
Wavelength : 760 nm – 800 nm
Emission duration : Continuous
LED light
CLASS 1 LED PRODUCT
R When using the unit, do not look directly at the CIS's
LED light. Direct eye exposure can cause eye
damage.
CIS's LED light properties
LED radiation output : Max. 1 mW
Wavelength :
Red : 630 nm typical
Green : 520 nm typical
Blue : 465 nm typical
Emission duration : Continuous
Fuser unit
R During or immediately after printing, the fuser unit
(A) gets hot. This is normal. Do not touch the fuser
unit.
Note:
R The area near the output tray (B) may also get warm.
This is normal.
A
For best performance
Toner cartridge and drum cartridge
R When replacing the toner cartridge or drum cartridge,
do not allow dust, water, or liquids to come in contact
with the drum. This may affect print quality.
R For optimal performance, genuine Panasonic toner
cartridges and drum cartridges are recommended.
We cannot be responsible for problems that may be
caused by a non-Panasonic toner cartridge or drum
cartridge:
– Damage to the unit
– Poor print quality
– Improper operation
Toner cartridge
R Do not leave the toner cartridge out of the protective
bag for a long time. It will affect the printing quality.
Drum cartridge
R Read the instructions on page 10 before you begin
installation of the drum cartridge. The drum cartridge
contains a photosensitive drum. Exposing it to light
may damage the drum.
– Do not expose the drum cartridge to light for more
than 5 minutes.
– Do not touch or scratch the black drum surface.
– Do not place the drum cartridge near dust or dirt,
or in a high humidity area.
– Do not expose the drum cartridge to direct
sunlight.
R To extend the life of the drum cartridge, the power
switch should never be turned OFF immediately after
printing. Leave the power turned ON for a minimum
of 30 minutes after printing.

Important Information

B
3