Panasonic KX-MB2085CX Operating Instructions Manual page 86

11. Help
Display
"REMOVE DOCUMENT"
"REMOVE PAPER IN INPUT
TRAY #2"
"RX MEMORY FULL"
"SLEEP"
"TONER EMPTY"
"TONER LOW"
"TOP COVER OPEN"
"TRANSMIT ERROR"
86
Cause & Solution
R The document is jammed. Remove the jammed document (page 103).
R Attempted to send or copy a document longer than 600 mm using the
automatic document feeder. Press MSTOPN to remove the document. Divide
the document into two or more sheets and try again.
R The ADF top cover is not fully closed. Push firmly on the front and rear edges
of the ADF top cover, and then feed the document again.
R The recording paper is installed in the manual input tray when trying to
receive faxes or print reports. Remove the recording paper from manual
input tray.
R The memory is full of received documents due to a lack of recording paper
or a recording paper jam. Load paper (page 14) or remove the jammed
paper (page 98).
R If the PC fax (feature #442 on page 64) is set to "ALWAYS",
– check the connection between the computer and the unit.
– check that the computer is turned ON.
R If your unit is connected to the computer via the LAN and the fax preview
mode (feature #448 on page 51) is set to "ON",
– view, print or save the received fax documents, and then erase the
unnecessary documents (page 51).
– turn the setting to "OFF". The fax documents stored in memory will be
printed automatically.
R After the unit has been in power save mode (feature #403 on page 59) for
up to 5 minutes, the unit will enter sleep mode. Press a key to standby the
unit for the next process.
Note:
R The unit may not enter sleep mode when beeping for alert or displaying an
error message.
R The toner is empty. Replace the toner cartridge immediately.
R The toner is reaching the end of its life. You will need to replace the toner
cartridge soon.
R The top cover is open. Close it.
R A transmission error occurred. Try again.