Description - Hilti TE 30 Operating Instructions Manual

Obligation signs
en Wear eye Wear a hard
protection
Wear
breathing
protection
Symbols
Read the Equipped
operating with theft
instructions protection
before use system
Double Drilling
insulated without
hammering

2 Description

2.1 Use of the product as directed
The power tool is an electrically-powered rotary hammer with pneumatic hammering mechanism.
The power tools are designed for drilling in concrete and masonry. The power tool can also be used for light chiseling
work on masonry and surface finishing on concrete.
Working on materials hazardous to the health (e.g. asbestos) is not permissible.
Nationally applicable industrial safety regulations must be observed.
The working environment may be as follows: construction site, workshop, renovation, conversion or new construction.
The power tool may be operated only when connected to a power supply providing a voltage and frequency in
compliance with the information given on its type identification plate.
The power tool is designed for professional use and may be operated, serviced and maintained only by trained,
authorized personnel. This personnel must be informed of any special hazards that may be encountered. The power
tool and its ancillary equipment may present hazards when used incorrectly by untrained personnel or when used not
as directed.
To avoid the risk of injury, use only genuine Hilti accessories and insert tools.
Observe the information printed in the operating instructions concerning operation, care and maintenance.
Modification of the power tool or tampering with its parts is not permissible.
2.2 Chuck
TE‑C (SDS plus) chuck
TE‑T (SDS top) chuck
2
Wear ear
hat protection
Lock symbol
1
Drilling
without
hammering,
1st gear
Hammer
drilling
Wear
protective
gloves
Revolutions
per minute
Location of identification data on the power tool
The type designation can be found on the type identifica-
tion plate and the serial number on the side of the motor
housing. Make a note of this data in your operating in-
structions and always refer to it when making an enquiry
to your Hilti representative or service department.
Type:
Return waste
material for
recycling.
Generation: 01
Serial no.:
2
Drilling
without
hammering,
2nd gear
Chiseling Chisel
position
adjustment
Revolutions
per minute