Description - Hilti C 4/36-90 Operating Instructions Manual

Hide thumbs Also See for C 4/36-90:
Table of Contents

Advertisement

Symbols
en
Read the
operating
instructions
before use.
Double insulated
Location of identification data on the appliance
The type designation and serial number can be found on the type
identification plate on the appliance. Make a note of this data in
your operating instructions and always refer to it when contacting
your Hilti representative or service center.
Type:
Generation: 01
Serial no.:

2 Description

2.1 Use of the product as directed
The appliance is used to charge Hilti Li-ion batteries with a rated
voltage of 7.2 to 36 volts.
The working environment may be as follows: construction site,
workshop, renovation, conversion or new construction.
The appliance is not intended for wall mounting.
Good air circulation around the appliance must be ensured.
Tampering with or modification of the appliance is not per-
missible.
Observe the information printed in the operating instructions
concerning operation, care and maintenance.
Nationally applicable industrial safety regulations must be ob-
served.
Observe the safety precautions and operating instructions for the
accessories used.
To avoid hazards, use only batteries of the approved type.
The appliance is designed for professional use and may be oper-
ated, serviced and maintained only by trained, authorized person-
nel. This personnel must be informed of any special hazards that
may be encountered. The appliance and its ancillary equipment
may present hazards when used incorrectly by untrained person-
nel or when used not as directed.
The appliance may be operated only when connected to an electric
supply providing a voltage and frequency in compliance with the
information given on its type identification plate.
Do not use the battery as a power source for other unspecified
appliances.
2.2 Items supplied as standard
1 Charger
1 Operating instructions
2.3 Charge status of the Li­ion battery during charging
LEDs light constantly
LED 1,2,3,4
LED 1,2,3
LED 1,2
LED 1
-
2
Printed: 08.07.2013 | Doc-Nr: PUB / 5129974 / 000 / 02
The disposal of
batteries with
household waste
is not
permissible.
LEDs blink
-
LED 4
LED 3
LED 2
LED 1
Return waste
material for
recycling.
Charge status
in %
= 100 %
75 % to 100%
50 % to 75 %
25 % to 50 %
< 25 %
For indoor use
only
2

Advertisement

Table of Contents
loading

This manual is also suitable for:

C 4/36-350

Table of Contents