Power Supply; Setting Up And Aligning The Scale - Seca 704 Instruction Manual And Guarantee

Power supply

The scale is generally powered by batteries.
The LC display has a low power consumption – 16.000 weighing operations can be per-
formed with one set of batteries.
– Push the battery compartment closure
towards "Battery" and open the cover.
– Connect the cable to the holder and
batteries.
– Place the holder in the battery compart-
ment.
– Close the cover.
Note: the scale is prepared for use
with a seca mains unit which is availa-
ble as an accessory.
– The socket for connecting the mains
unit is located at the bottom of the col-
umn.
Note: the mains unit can also be used
with the batteries in place without the
scale or batteries being damaged.

4. Setting up and aligning the scale

– Place the scale on a level surface.
– Align the scale by undoing the foot
screws. The air bubble in the spirit level
must be right in the centre of the circle.
– Ensure that only the feet of the scale are
in contact with the floor. The scale may
not be in contact at any other point.
Important!
The alignment of the base of the scale
must be checked and corrected if nec-
essary every time the location of the
scale is changed.
18
spirit level