Ifly-4 Installation And Setup; Ifly-4 Installation - Idea-fly IFLY-4 User Manual

1. IFLY-4 Installation and Setup

Before flying the IFLY-4 it is necessary to install and setup your radio transmitter and receiver so
that the IFLY-C4 Flight Controller (FC) can respond correctly to your flight commands. These
instructions will take you through the initial installation and setup of the IFLY-4.

2. IFLY-4 Installation

2.1 Connect your chosen receiver to the IFLY-4C Flight Controller according to the
schematic below;
A – Connect to the AILERON channel of the receiver
E – Connect to the ELEVATOR channel of the receiver
T – Connect to the THROTTLE channel of the receiver
R – Connect to the RUDDER channel of the receiver
F – Connect to a spare channel of the receiver (eg. GEAR). 2 position switch to change
flight mode – Balanced (auto-stabilised) and Manual (non-stabilised)
S1 – Connect a spare channel of the receiver for manual Camera PITCH control
(optional)
S2 – Connect a spare channel of the receiver for manual Camera ROLL control
(optional)
P1 – Connect the Camera PITCH (Tilt) servo to this port (optional).
P2 – Connect the Camera ROLL servo to this port (optional).
Observe the polarity. The signal wire is uppermost and closest to the FC label.
2.2 Securely fasten your receiver onto the IFLY-4 frame using double sided foam tape.
2.3 Set your radio transmitter to Airplane mode.
2.4 All settings within the radio transmitter programming e.g. DR/EXPO etc. are still
functional and can be used to tune the IFLY-4 characteristics.
2.5 If you are using 2.4G- BIND your receiver to your transmitter (refer to your
transmitter's manual).
FRONT