Idea-fly IFLY-4 User Manual page 3

2.6 Loosen the 4 finger bolts from the underside of the IFLY-4 and unfold the 4 frame arms
into their flying position.
2.7 Tighten the 4 finger bolts to secure the frame arms into the flying 'X' configuration.
2.8 Note: The bolts only need to be finger tight. Use of additional tooling may over-tighten
the bolts and lead to damage.
2.9 Clip on the two landing gear struts to the underside of the IFLY-4.
2.10 Note: It is recommended to install each side of the landing gears strut one after
the other to avoid overstressing the gear.
2.11 Push the two landing gear skids through the landing gear struts to complete the
installation.
Completed installation
Finger Bolt x4
Landing Gear Mount x4