Adtec RD-60 User Manual page 20

Downscaling The Downscaling SDI setting
SDI determines whether the SDI
bank ( SDI Output 1 and 2 ) will
be output natively or downscaled
to SD.
Downscaling The Downscaling SDI setting
SDIALT determines whether the SDI
bank ( SDI Output 3 and 4 ) will
be output natively or downscaled
to SD.
Genlock Menu
Genlock Mode Configures the genlock operation
of the decoder. SLAVE is
primarily used for 3D applications
and REMOTE is used in standard
genlock operation.
Horizontal Horizontal adjustment defines
Adjust the difference in the SYNC IN
HSYNC and output HSYNC.
Typically, this should be in the
range of 0 to +1 line in clocks.
For example, a 1080I output
could be adjusted from 0 to
2200.
Vertical Adjust Vertical adjustment defines the
difference in the SYNC IN VSYNC
and output VSYNC. Typically, this
should be in the range of 0 to +1
frame in lines. For example, a
1080I output could be adjusted
from 0 to 1125.
Pixel Phase Pixel Phase adjustment is a very
fine grain adjustment that can
adjust within a single clock. The
increments are 1/64th of a clock.
The valid range is 0 to 63.
Genlock Status Shows if GENLOCK input is
currently being used for the
decoder or in FREE RUN mode
Genlock CVBS This configuration is used
will be used.
OFF
SD
OFF
SD
OFF - Disables genlock
SLAVE - Enable Genlock, Decode
source is synchronous to SYNC IN
signal
REMOTE - Enable genlock, Decode
source is NOT synchronous to SYNC
IN signal
0 - 2200
0 - 1125
0 - 63
VIDEO - CVBS output is video