Transport Led Indicators; Audio Decode Indicators - Adtec RD-60 User Manual

2) Disabled Product State: When the product is in a disabled state, the LCD will relay the
following information. This state is generally only used when a factory restore is performed.
If that is the case, note that all of the configurations have been returned to factory defaults
including Network configurations. To reapply network configurations simply press the Down
arrow when in this state to navigate through the network menu.

Transport LED Indicators

Indicator Function
Decode Off - Decoder is idle.
On - Decoder is active.
ASI / IP /RF Off - No services detected on the input.
On - Services detected on the input.
Lock 1 / Lock 2 Off - Tuner is not locked
On - Tuner is locked
IP Out Off - IP Egress is idle.
On - IP Egress is active.
* IP Output is not applicable for RD-60 products
Bars Off - All B/T/ID options are disabled.
On - B/T/ID options are enabled.

Audio Decode Indicators

Indicator Function
A1 through A8 Off - Audio engine is not active.
On - Audio engine is actively decoding or performing pass-through.
Blinking - Audio engine is in a failure mode ( no pass-through or audio
decoding )