Voice Announcement - Motorola APX 1000 User Manual

•
Press the Menu Select button below Rej to
reject the request to upgrade.
One of the following scenarios occurs:
• If you choose to accept, the display shows
Programming Dont power off to indicate the
upgrade is about to begin. The radio resets to
install the upgrade. In the case of configuration
data upgrade, this process only takes a few
seconds. In the case of firmware upgrade, the
installation takes several minutes.
Note:
The radio cannot be used while the
upgrade is being installed. Therefore, make
sure to only accept the upgrade at a
convenient time when immediate radio use
is not required.
• If you choose to delay, a configuration data
upgrade is installed automatically at the next
power up. However, in the case of a firmware
upgrade, the radio prompts Upgrade? again at the
next power up.
•
If you choose to reject, the display shows Upg
Aborted. The radio continues to function with the
current configuration until it gets reprogrammed.
Note:
If your radio has problems upgrading over-the-
air, consult a qualified technician for details.

Voice Announcement

This feature enables the radio to audibly indicate the
current feature mode, zone or channel the user has
just assigned. This audio indicator can be customized
per customer requirements. This is typically useful
when the user is in a difficult condition to read the
content shown on the display.
Each voice announcement is within a limit of three
seconds maximum. The sum duration of all different
voice announcements in a radio shall be no more
than 1000 seconds.
Note:
This feature must be preprogrammed by a
qualified radio technician.
Check with your agent if Voice Announcement
is available for the feature you need.
The two options of priority for the Voice
Announcement available are:
61
English