General Data Capture; Procedure 30 Obtaining The Wired And Wireless Captures - Nortel NN43001-504 Installation Manual

General data capture

Before you run the show run-config or debug commands, enable text
capturing on your Hyper terminal or Telnet application that you use to
access the WLAN Security Switch 2270.
Multiple times is better—copy and paste the following commands on the
WLAN Security Switch 2270 CLI, rather than typing them individually. The
screen begins scrolling with output as soon as you type the commands.
•
•
•
The wired sniffer must sniff the Gig port of the WLAN Security Switch 2270.
No capture filter is required; get everything.
Obtain the wireless capture from the channel that the handsets currently
use. Configure the wireless sniffer to capture from only one channel. To
determine which channel, first show the client summary. Look for the MAC
of the client showing status associated and note the name of the AP beside
it. To see the channel that the AP operates on, show the advanced 802.11b
summary.
Follow the steps in
captures" (page
Procedure 30
Obtaining the wired and wireless captures
Step
1
2
3
Copyright © 2004-2007, Nortel Networks
.
show run-config (from all WLAN Security Switch 2270s)
show tech support
show msglog
Procedure 30 "Obtaining the wired and wireless
217), to capture data to send to Nortel for analysis.
Action
Run the command:
debug airwave-director all enable
Let this command run for 5 to 7 minutes.
Run the command:
debug disable-all
Run the following debug commands from the WLAN Security Switch
2270 (that you are testing) in the CLI:
debug dot11 mobile enable
debug dot11 state enable
debug mobility directory enable
debug mobility handoff enable
debug pem state enable
debug pem events enable
show debug
Nortel Communication Server 1000
WLAN IP Telephony Installation and Commissioning
NN43001-504 01.02 Standard
Release 5.0 15 June 2007
Data capture 217