Lan Connection; Power Connection; Wlan Application Gateway 2246 Installation; Connecting The Power - Nortel NN43001-504 Installation Manual

4

LAN connection

Use an RJ-45 cable to connect the NETWORK port on the WLAN IP
Telephony Manager 2245 to the connecting port on the Ethernet switch.

Power connection

Follow the steps in
connect the power to the WLAN IP Telephony Manager 2245.
Procedure 4

Connecting the power

Step
1
2
3

WLAN Application Gateway 2246 installation

For information about installing the optional WLAN Application Gateway
2246, see
Copyright © 2004-2007, Nortel Networks
.
Repeat steps 1-3 for each additional WLAN IP Telephony Manager
2245. The mounting plate is designed to provide the correct
minimum spacing between units. When mounting multiple units,
stack the units in the rack as closely as possible.
Procedure 4 "Connecting the power" (page 97)
Action
Connect the power plug from the AC adapter to the jack labeled
PWR on the WLAN IP Telephony Manager 2245.
WARNING
Use only the provided Class II AC adapter with output
24V DC, 1A.
Plug the AC adapter into a 110V AC outlet to supply power to the
WLAN IP Telephony Manager 2245.
The system cycles through diagnostic testing and the LEDs blink for
approximately one minute.
When the system is ready for use, verify the following:
a. ERROR LED is off.
b. Status 1 is blinking.
Appendix "WLAN Application Gateway 2246" (page
Nortel Communication Server 1000
WLAN IP Telephony Installation and Commissioning
NN43001-504 01.02 Standard
Release 5.0 15 June 2007
WLAN Application Gateway 2246 installation 97
—End—
—End—
to
147).