Manufacturer's Warranty - Tools; Ec Declaration Of Conformity (Original); Confirmation Of Cip Testing - Hilti DX 36 Operating Instructions Manual

12 Manufacturer's warranty - tools

Hilti warrants that the tool supplied is free of defects in
material and workmanship. This warranty is valid so long
as the tool is operated and handled correctly, cleaned
and serviced properly and in accordance with the Hilti
Operating Instructions, and the technical system is main-
tained. This means that only original Hilti consumables,
en
components and spare parts, or other products of equi-
valent quality, may be used in the tool.
This warranty provides the free-of-charge repair or re-
placement of defective parts only over the entire lifespan
of the tool. Parts requiring repair or replacement as a
result of normal wear and tear are not covered by this
warranty.

13 EC declaration of conformity (original)

Designation:
Type:
Generation:
Year of design:
We declare, on our sole responsibility, that this product
complies with the following directives and standards:
2006/42/EC, 2011/65/EU.

14 Confirmation of CIP testing

The following applies to C.I.P. member states outside
the EU and EFTA judicial area: The Hilti DX 36 has been
system and type tested. As a result, the tool bears the
rectangular PTB approval mark showing approval num-
ber S 801. Hilti thus guarantees compliance with the ap-
32
Powder-actuated fasten-
ing tool
DX 36
01
1986
Additional claims are excluded, unless stringent na-
tional rules prohibit such exclusion. In particular, Hilti
is not obligated for direct, indirect, incidental or con-
sequential damages, losses or expenses in connec-
tion with, or by reason of, the use of, or inability to
use the tool for any purpose. Implied warranties of
merchantability or fitness for a particular purpose are
specifically excluded.
For repair or replacement, send the tool or related parts
immediately upon discovery of the defect to the address
of the local Hilti marketing organization provided.
This constitutes Hilti's entire obligation with regard to
warranty and supersedes all prior or contemporaneous
comments and oral or written agreements concerning
warranties.
Hilti Corporation, Feldkircherstrasse 100,
FL‑9494 Schaan
Norbert Wohlwend
Head of Quality & Processes Manage-
ment
BU Direct Fastening
04/2013
Technical documentation filed at:
Hilti Entwicklungsgesellschaft mbH
Zulassung Elektrowerkzeuge
Hiltistrasse 6
86916 Kaufering
Deutschland
proved type. Unacceptable defects or deficiencies, etc.
determined during use of the tool must be reported to the
person responsible at the approval authority (PTB) and
to the Office of the Permanent International Commission
(C.I.P.).
Tassilo Deinzer
Head BU Measuring Systems
BU Measuring Systems
04/2013