Table of Contents
Advertisement
Installation checklist
This checklist represents the high-level tasks that must be performed to
successfully install the Nortel Secure Network Access Switch. Device
installation involves the following steps:
Procedure steps
Step
1
2
3
4
5
6
Copyright © 2008, Nortel Networks
.
Action
Choose a suitable location to install the device.
Use the information contained in the following sections to determine
where the device should be installed:
•
Safety and installation precautions
•
Hardware specifications
Unpack the device from the shipping container.
Unpack all items from the original packaging and determine if all
items have been shipped. All items listed in Package contents
should be present. If items are missing, contact the party from whom
the Nortel Secure Network Access Switch was purchased.
Mount the switch.
To rack mount the Nortel Secure Network Access Switch, see the
Installing the Nortel SNAS 4070 in Nortel Secure Network Access
Installation — Switch, NN47230-302.
The Nortel Secure Network Access Switch is intended to be installed
in a 4 post server rack. The device cannot be installed in a 2 post
equipment rack. It needs to be installed in a server rack, which is
a 4 post rack.
Connect the device power units to an appropriate, properly grounded
power source.
Connect network cables to the device.
Power on the switch by depressing the power button on the front
of the unit.
Nortel Secure Network Access
Installation — Quick Start Switch 4070
NN47230-303 01.01 Standard
2.0 28 July 2008
Installation checklist 23
—End—
Advertisement
Table of Contents
