Table of Contents
Advertisement
Procedure steps
Step
1
2
3
4
5
Copyright © 2008, Nortel Networks
.
Action
Choose join from the Setup menu to add an SNAS to an existing
cluster.
Specify the port to be used for network connectivity.
Enter port number for the management interface [1-3]:
This port is automatically assigned to Interface 1. This interface
can be used for both management traffic (coming from the private
intranet) and client traffic (coming from the public Internet).
If port 1 is the management interface port for existing SNAS(s),
Nortel recommends that you configure port 1 for the new SNAS
as well.
Enter the new SNAS host IP address.
This IP address should be within the same network address range
as the cluster's Management IP address.
Enter the network mask.
Specify the desired network mask or press Enter to accept the
suggested value. If a connected router or switch attaches VLAN tag
IDs to incoming packets, specify the VLAN tag ID to use.
Press Enter to create a one-armed configuration.
Nortel Secure Network Access
Installation — Quick Start Switch 4070
NN47230-303 01.01 Standard
2.0 28 July 2008
Joining an SNAS to an existing cluster 37
Advertisement
Table of Contents
