Special Wash Cycles And Options - Hotpoint Ariston LSFF 8M117 Operating Instructions Manual

Hide thumbs Also See for LSFF 8M117:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 14
Special wash cycles
and Options
Notes:
EN
Optimum performance levels when using the "Express" cycle
can be achieved by respecting the specified number of place
settings.
To reduce consumption even further, only run the dishwasher
when it is full.
Note for Test Laboratories: for information on comparative EN
testing conditions, please send an email to the following address:
assistenza_en_lvs@indesitcompany.com
Wash options*
The OPTIONS may only be set, changed or reset after the
wash cycle has been selected and before the Start/Pause
button has been pressed.
Only the options which are compatible with the type of wash
cycle set may be selected. If an option is not compatible
with the selected wash cycle
corresponding symbol flashes rapidly 3 times.
If an option is selected which is not compatible with another
(previously selected) option, it will flash 3 times and switch off,
while the most recently selected option will remain active.
To deselect an option which has been set by mistake, press the
corresponding button again.
Delayed start option
It is possible to delay the start time of the cycle by a
period of time between 1 and 24 hours:
1. Select the desired wash cycle and any other options
required; press the DELAYED START button. The indicator
light will go on. Use the same button to select when the wash
cycle will start (h01, h02 etc.)
2. Confirm the selection using the START/PAUSE button to
start the countdown.
3. Once this time has elapsed, the DELAYED START indicator
light goes off and the wash cycle begins.
To deselect the DELAYED START option, press the DELAYED
START button until the text OFF appears.
The Delayed Start function cannot be set once a wash
cycle has started.
*
Only available in selected models.
22
(see Table of wash cycles)
, the
Half load option using the upper or lower rack
If there are not many dishes to be washed, a half load
cycle may be used in order to save water, electricity
and detergent. Select the wash cycle and then press the HALF
LOAD button: the indicator corresponding to the chosen rack
lights up and the wash cycle starts only in the upper or lower rack.
Remember to load the upper or lower rack only, and to
reduce the amount of detergent accordingly.
Multi-functional tablets option (Tabs)
This option optimises washing and drying results.
When using multi-functional tablets, press the MULTI-
FUNCTIONAL TABLETS button; the corresponding symbol
will light up. If the button is pressed again, the option will be
deselected.
The "Multi-functional tablets" option results in a
longer wash cycle.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents