Hangar 9 Extra 260 Assembly Manual page 14


Step 4
Attach the ball end to the servo horn using the hardware
provided with the ball end. The attachment point will be
1
1 / -inch (38mm) from the center of the servo horn.
2

Step 5
Position the tail gear assembly on the bottom of the
fuselage. Use a felt-tipped pen to mark the locations for
the two screws.
Note: The tail gear will keep the rudder
hinge in position. You will need to trim the
removable hinge pin so it is 1/4-inch (4mm)
above the tail gear when it has been installed.
14

Step 6
Drill each of the locations using a drill and 3/32-inch
(2.5mm) drill bit.

Step 7
Thread a #6 x 5/8-inch socket head sheet metal screw into
the holes, then remove the screw.