Elevator Servo Installation
Required Parts
• Ball end w/hardware (2)
• Stabilizer/elevator (left and right)
• 3-inch (76mm) linkage (2)
Required Tools and Adhesives
• Hex wrench: 3/32-inch
• Nut driver: 1/4-inch
1
• 1
/
-inch Single Side Alum Adj. Spline Servo Arm
2
(2)
Step 1
Install the elevator servo into the stabilizer. Make sure to
pull the servo lead through the opening toward the leading
edge before placing the servo.
Step 2
Install the servo arm onto the elevator servo. Use the radio
system to center the servo beforehand.
12
• Control horn (2)
Step 3
Assemble the linkage for the elevator using a ball end,
control horn and a 3-inch (76mm) linkage. Thread the
horn onto the screw so the bottom of the horn is 3/4-inch
(19mm) from the surface of the elevator.
Step 4
Attach the ball end to the servo horn using the hardware
provided with the ball end. The attachment point will be
1
1
/
-inch (38mm) from the center of the servo horn.
2
Step 5
Repeat Steps 1 through 4 for the remaining elevator servo
and linkage.