Cleaning And Storage - Aztec Grand Finale Owner's Manual

PG. 4 GRAND FINALE

CLEANING AND STORAGE

!
IMPORTANT
1. After completing last pass, retract head assembly
and lock lift handle in transport position.
2. Place head cover over head assembly, pad
holder and pad. Close Velcro as far as
possible. This will minimize dripping and
prevent drying of pad.
3. If Grand Finale will be used within a short
period of time, the head cover may be placed
over head and pad holder to keep solution on
surfaces from drying.
!
IMPORTANT
4. If solvent based coatings are used, the Grand
Finale must be flushed with mineral spirits
before Step 1. Failure to clean the Grand
Finale as directed will void the warranty.
5. Remove suction hose from wax/coating
container and remove container. Cap unused
wax/coating. Place the Grand Finale cleaning
bucket containing two quarts of water on the
Grand Finale.
6. Disconnect suction hose and rinse in water.
Reconnect hose to Grand Finale and place in
water.
7. Remove the finish pad from the pad holder
and place in head cover.
A person who has not read and does not
understand all operating instructions is not
qualified to operate this tool.
Failure to read and understand safety
instructions may result in injury or
death.
!
WARNING
Disconnect power before working
Electric shock may occur
!
WARNING
8. Rinse out pad and head cover. Set pad and cover
aside to dry. Note: Pad can be machine washed.
9. Retract head assembly to cleaning position
and lock lift handle in place.
10. Place cleaning tray in front of Grand Finale
and position head over tray.
11. Turn Control knob to PRIME/CLEAN and
allow cleaning water to flow through the head
manifold for about 15 seconds or until
manifold is clean.
12. Disconnect suction hose and turn control
switch to PRIME/CLEAN to purge remaining
water from Grand Finale.
13. Open paper clip and use tip to clear solution
from groove in distribution tube.
14. Push end of paper clip through any plugged
holes to clear holes.
15. After cleaning head, dump water from
cleaning tray.
16. Disconnect lift handle from the head, store
handle in the transport notch position and
resting in the transport bracket.
17. Disconnect feed hose and remove head
assembly, rinse off and store with pad in head
cover.
18. Dump water from cleaning bucket. Store
suction hose in cleaning bucket.
19. DO NOT ALLOW THE UNIT TO FREEZE!
SAVE THESE
INSTRUCTIONS!
Failure to clean the
Grand Finale as directed
will void the warranty.