Stadler Form ALBERT Operating Instructions Manual page 11

• the appliance shall be installed in accordance with national wiring regu-
lations.
Setup / operation
1. Place albert little on a flat surface in the desired area. Plug the power
cable (13) into an electric socket.
2. Press the on/off switch (3) to turn on the dehumidifier.
3. you can select the speed of the fan in the dehumidifier by pushing
the speed level selector (5). there are 2 speed levels. If the speed is
higher, the dehumidifying performance also increases.
4. with the hygrostat (4) the desired humidity level can be set (Con = con-
tinuos). a humidity level not higher than 60% is suggested in general.
If the dehumidifier reached the selected humidity it will turn off and
after that check the humidity level in constant intervals by turning on
the fan for a short time.
5. the swing mode (6) allows to distribute the dry air well in the room.
this mode is also suitable for example to dry clothes fast and efficient.
6. If you find the display and Led too bright (in a bedroom for example),
you may reduce the light intensity by pressing the night mode (7). the
fan will also be reduced in this mode to slow speed.
7. Once the water tank is full, the blinking symbol will appear on the
display and the dehumidifier turns off automatically. Please empty the
tank. Once you put back the tank, the unit will automatically restart.
8. defrost function: If the temperature in the room is below 16°C, the
dehumidifier automatically runs in defrost mode. this mode is shown
on the display and frost build up in the unit will be avoided during
dehumidification. It runs every 25 minutes during 7 minutes.
9. If desired, it is possible to connect a drainage hose to the unit for
permanent water drainage. In this case connect the hose (14) to the
unit through the hole in the back of the dehumidifier and place the
end of the drainage in a water outlet. Please make sure the end of the
hose is lower than the spout, otherwise the water will not drain and
flooding may occur.
10. For easy side movement of the unit there are hidden wheels (15) at-
tached. empty the tank first before moving the dehumidifier.
Cleaning
Before servicing the appliance and after each occasion of use, switch off
the appliance and unplug the mains cable from the socket.
• attention: never immerse the appliance in water (danger of short-circuit).
• to clean the appliance, only wipe it down with a damp cloth and then dry
it carefully.
• In case the filter (10) at the air inlet (9) is dirty or dusty, take the filter out
and remove the dirt/dust with a vacuum cleaner.
• If you don't use the dehumidifier for some time, empty the water tank and
dry the unit fully before storing it in its original carton.
Repairs/disposal
• repairs to electrical appliances must only be carried out by a qualified
electrical technician. If improper repairs are carried out, the guarantee
lapses and all liability is refused.