Cleaning The Steam Mop; Troubleshooting - Piranha NV-608 User Manual

11.3 Cleaning the Steam Mop

Do not clean the Steam Mop, components or accessories with petrol or
any other flammable liquids, solvents, etc.
Use only a moist cloth and mild detergent for cleaning the outside of the
Steam Mop.
After cleaning, wipe off the moisture with a dry cloth.
Do Not place in water or liquid to clean.

12 Troubleshooting

PROBLEM
Unit fails to heat up.
Red Power Indicator Light
DOES NOT illuminate.
Unit fails to heat up. Red
Power Indicator Light DOES
illuminate; green Heating
Indicator Light DOES NOT
illuminate.
Unit heats up, but fails to
steam. Both red Power
Indicator Light and
Heating Indicator Light DO
illuminate.
NOTE: Always allow sufficient
time for unit to heat up and
begin producing steam.
Steam output is weak or
intermittent.
Excessive moisture left on
floor during mopping.
NOTE: It is normal for some
amount of moisture to be left
behind. Allow floor some time
to air-dry once mopping is
complete.
Floor surfaces appear cloudy
or streaky after steaming.
POSSIBLE CAUSE
Unit is not plugged in.
Unit's main power is not on.
Household circuit breaker / Safety
Switch has tripped or blown a fuse.
Unit is damaged or otherwise in
need of repair.
No water in Water Tank / Boiler.
Mineral build-up in unit.
green
Unit is damaged or otherwise in
need of repair.
Water level in Water Tank / Boiler is
running low.
Mineral build-up in unit.
Microfiber Pad
saturated with moisture.
Boiler has been overfilled.
Microfiber Pad
oversaturated.
Hard water residue on floor.
Unsuitable Surface for Steaming
Plug into electrical outlet.
Press On/Off Switch until it clicks ON.
Reset circuit breaker / Safety switch, or replace fuse. For
assistance, contact a licensed electrician.
Immediately cease use and unplug. Contact Customer
Service for assistance
Refer to "Adding Water" section for adding water
procedure.
Refer
procedure.
Immediately
Consumer Service for assistance. Refer Warranty Page.
Refer to "Refilling" section for procedure on adding more
water.
Refer
procedure.
Remove pad and replace with fresh dry one. To
has become
purchase additional Pads, contact Consumer Service
(see Warranty Page for contact details).
Filling Water Tank / Boiler with more than 250ml of water
interferes with steam production, resulting in excess
water droplets in the steam.
Drain some water out of Water Tank/ Boiler. Always use
included Measuring Cup to fill Water Tank / Boiler with
correct amount of water. Refer to "Refilling" section for
procedure on emptying and adding more water.
is dirty /
Replace pad with clean dry one.
Use distilled water only.
Refer to Clause 9 for advice on surfaces.
Page 14 of 15
SOLUTION
to "Mineral Build-up"
cease usage and
to "Mineral Build-up"
section for cleaning
unplug. Contact
section for cleaning