Maintenance; Mineral Build-Up - Piranha NV-608 User Manual

If the pad is dirty you may wash it, Refer to section "Maintenance" for
cleaning instructions.
4. Unscrew and remove the Water Tank / Boiler Cap. Drain any water
remaining in Water Tank / Boiler into a sink or tub, to minimise potential
mineral build-up and prevent overfilling during next use. Replace the
Water Tank / Boiler Cap (do not fully tighten).
5. Reconnect the Telescopic Tube if removed previously. If desired,
collapse the Telescopic Tube to its shortest length (ideal for limited
storage space). Refer to section "Assembly" for instruction.
6. The power cord can be stored away by winding around the two Cord
Storage Hooks.
7. Store your Steam Mop in a Cool, dry location, along with all the included
accessories.

11 Maintenance

WARNING: The appliance must be switched off and the plug must be
removed from the power point before any maintenance, cleaning or replacing
the Microfibre Pads.

11.1 Mineral Build-Up

A common maintenance need for steam appliances is removal of build-up
caused by high mineral contact in many municipal water supplies. This
mineral build-up limits the effectiveness and reduces the life of your Steam
Mop.
The best way to minimise mineral build-up is to use distilled or de-
mineralised water when using your Steam Mop. In addition, it is
recommended that the Water Tank / Boiler be cleaned at least once a
month in order to remove any deposits that form. This will help to extend
the life of your Steam Mop and keep it functioning at its maximum potential.
To remove mineral build-up:
1. Gently press down the On/Off Switch until it clicks – The Red Power
Indicator Light will turn off. Unplug the power cord from the electrical
power outlet.
IMPORTANT: The Unit must remain off and unplugged during the cleaning
procedure.
Page 12 of 15