Cleaning Your Steam Cleaner; Troubleshooting - Piranha YQ-3888 User Manual

13 Cleaning Your Steam Cleaner

• Turn off and unplug appliance prior to cleaning and let cool.
• Do Not immerse the appliance in water, or any other liquid.
• Rinse out the water chamber with clean fresh cold water.
• Do not allow detergents etc to enter the boiler as this will damage the appliance.
• Wipe the outer surface of the appliance with a soft damp cloth and dry with a dry towel.
• Do not use abrasive creams, solvents, steel wool or scouring pads as they will damage the
finish.
• All removable components should be detached and cleaned thoroughly in warm, soapy
water at regular intervals.
• Do Not place appliance or components in the dishwasher.
CAUTION: DO NOT IMMERSE MAIN BODY IN WATER OR LIQUID.

14 Troubleshooting

No Steam.
Water is ejected
instead of steam.
A small amount of
water is ejected instead
of steam
Light turns On and Off
during use.
Light will not come on.
Power Not Switched On.
No water in the tank.
Thermal Fuse Blown
Too much water in the water tank.
Unit tipped over more than 45°
This is normal when the Steam
Valve initially opens or as the
pressure drops.
Indicates the temperature is being
maintained.
No Power being supplied to the
Steam cleaner.
Thermal Fuse has Blown
Page 13 of 14
Switch On at power point.
Add water to the water tank.
Call service department
Empty some water
Maximum of 250ml to be
used.
Hold Unit upright more
This is normal
This is normal
Check your power point to
see if power is available.
Call service department
out.