Related Manuals for Piranha JJB-603
Summary of Contents for Piranha JJB-603
- Page 1 Steam Mop User Manual Model No.: JJB-603 Item No.: 900255 230 - 240Va.c. 50Hz 800W Rev 2 READ AND SAVE THESE INSTRUCTIONS...
-
Page 2: Table Of Contents
Warnings .................. 3 Safety Direction ............... 3 Transporting your Steam Mop ..........4 Specification ................5 Components ................5 Assembly ................. 6 Micro Fibre Pad ............... 6 Operation ................. 7 User Maintenance ..............8 Cleaning the Micro Fibre Pads ..........8 Cleaning the Steam Mop ............ -
Page 3: Warnings
Warnings Before using this appliance, read and follow all warnings and instructions in this manual, even if you are familiar with this product. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety.. -
Page 4: Transporting Your Steam Mop
It is highly recommended to disconnect the plug from wall socket and let cool before changing the micro fibre cleaning pads. This appliance must be earthed. The use of an Earth Leakage Safety Switch is highly recommended. Refer to your electrician for further information. This product can be used for cleaning floor surfaces such as sealed wooden floors, ceramic tiles, granite and marble flooring, including some types of carpet. -
Page 5: Specification
Specification Supply: 230 - 240Va.c. 50Hz Rated Power: 800W 300ml – NOTE. Do not fill more than 250ml from empty. Tank Capacity: Heat Up Time: Up to 3 minutes. Steam Rate: 25g/m approximate. Components Handle to Tube Coupler Handle Grip with Cord Hook Telescopic Tube Locking Button... -
Page 6: Assembly
Assembly A small amount of assembly is required when you receive your steam mop. • First, remove all the components from the packaging. • Take the Handle Grip and fit it to the top of the telescopic tube and fix in place by screwing up and tightening the Tube Coupler. -
Page 7: Operation
Operation • After fitting the Micro Fibre Pad, place the steam mop on the rubber mat supplied. Note: Ensure the Micro Fibre Pad is fitted before use. • Unscrew the Water Fill Cap and remove. • Using the 250ml beaker supplied, pour 250ml of clean water into the water tank then refit the cap and tighten securely. -
Page 8: User Maintenance
• At this time, start to push and pull the Steam Mop over the floor as if you are vacuuming the floor. • If you need to stop cleaning the floor i.e. you need to move an object, or the phone rings, and steam is still being ejected from the base, press the On / Off switch on the back of the Steam Mop and then place the Steam Mop on the rubber mat supplied. -
Page 9: Cleaning The Steam Mop
9.2 Cleaning the Steam Mop Do not clean the Steam Mop or components with petrol or any other flammable liquids, solvents, etc. Use only a moist cloth and mild detergent for cleaning the Steam Mop. Clean only the outside of the Steam Mop. After cleaning, wipe off the moisture with a dry cloth. -
Page 10: Warranty Against Defect
11 Warranty Against Defect WHAT’S COVERED? 5.2 Our goods come with guarantees that cannot be excluded under Australian Consumer Law. You H.E. Group Pty Ltd (“us” “we” or “our”) are entitled to a replacement or refund for a warrants this good for a full replacement or major failure and compensation for any other refund for a period of twelve months from reasonably foreseeable loss or damage.