Refilling; Steam Mopping - Piranha NV-608 User Manual

8.2 Refilling

If the unit has been in use, always take the following safety precaution
before removing the Water Tank / Boiler cap and adding any water:
•
Allow the unit to cool for 5 -10 minutes. This will reduce heat and pressure
inside the Water Tank / Boiler, helping to prevent escaping steam when the
Water Tank / Boiler Cap is removed as well as vaporisation when more
water is added.
•
Once this is done, follow the "Adding Water" procedure.
WARNING: Failure to follow this precaution may result in burns from
escaping steam when the Water Tank / Boiler cap is removed or when
water is poured into the Water Tank / Boiler
8.3

Steam Mopping

Before operating, make sure the Microfibre Pad is properly attached and
the Water Tank / Boiler is filled with water. (Max 250ml)
1. Plug the power cord into a convenient electrical outlet.
2. Place the Resting Pad on the floor, with the textured side facing upward.
Rest the Mop Head on top of the pad, in order to help protect floor
surface from excess heat and moisture during heat-up period.
3. Using your foot, gently press down on the On/Off Switch on the back of
the Mop Head until it clicks. The Red Power Indicator Light will illuminate
to show that the unit is receiving power. At the same time, the Green
Heating Indicator Light will illuminate to show that Boiler is heating.
4. After approximately 3 minutes of heating time, the unit will begin emitting
steam.
5. Remove the unit from the Resting Pad, and begin mopping.
6. Refer to the list in section "Recommended Floor Surfaces" for a listing of
floor surfaces that are recommended for cleaning with your Steam Mop.
Page 9 of 15