Door Handle Removal; Door Handle Installation - Viking VCSF036SS Service Book

To avoid risk of electrical shock, personal injury, or death, disconnect power to unit before servicing,
unless testing requires power.

Door Handle Removal

Condition Requirements:
None
1. Remove plastic button plug at base of handle with a
very small flat-blade screwdriver.
2. Insert phillips screwdriver into predrilled hole to
remove screw.
3. Slide handle down and remove from door clip.
©2007 Viking Preferred Service
Disassembly Procedures
WARNING

Door Handle Installation

1. Loosen lower door clip on door with a phillips
screwdriver.
2. Locate predrilled hole at base of handle, and fit
hollow end of handle over lower door clip.
3. Fit other end of handle over upper door clip and
slide up as far as possible.
NOTE: If top of handle does not fit over top clip, loosen
lower clip further until fit can be accomplished.
4. Insert phillips screwdriver into predrilled hole at base
of handle to tighten screw. Insert plastic button plug
into hole.
57